Re-Sequencing Stops on a Shipment Creates Stop Type That Shows as PD
(Doc ID 2001269.1)
Last updated on JULY 20, 2024
Applies to:
Oracle Transportation Management - Version 6.3.4 to 6.3.7 [Release 6.3]Information in this document applies to any platform.
Symptoms
When Re-Sequencing Shipment Stops, OTM assigns a Stop Type of "PD" to the Shipments
The below example illustrates the issue as it occurs within 3 Steps
Step 1: ---> Select 3 orders "A, B and C" then Run a Bulk Plan for these 3 Orders - a 5 stop Shipment called XXXXXX is created for these 3 Orders, with Pickup and Drop-Off activities listed as "P" and "D" as listed below
Stop 2. P activity at B
Stop 3. D activity at B
Stop 4. D activity at C
Stop 5. D activity at A
Step 2: ----> Proceed to Open the Shipment XXXXXX then click on the Stops TAB then Click on the Actions Button>Shipment Management>Change Shipment Stops>Resequence Stops
Step 3: ----> Complete the Resequence Stops action by moving stop 4 to stop 2, resulting in the below 4 stops
Stop 2. PD activity at C
Stop 3. D activity at B
Stop 4. D activity at A
The Problem in this scenario is the Stop Type "PD" that is seen with stop 2.
Seeking a sure shot way in OTM to prevent the creation of "PD" stop type when the resequence stops process is completed
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
Symptoms |
Cause |
Solution |
References |