Last updated on SEPTEMBER 08, 2016
Applies to:Oracle Transportation Management - Version 6.3.4 to 6.3.8 [Release 6.3]
Information in this document applies to any platform.
When one creates a Shipment using Integration and one expects the following StopNums to get populated.
After the Shipment is created, under the Equipment tab, one does not see the PickUp and DropOff stop Numbers as shown.
However when the same XML is run one more time, the above gets populated.
After the Shipment is created, under the Equipment tab, one expects to see the PickUp and DropOff stop Numbers as shown, right after the first run of the XML file.
The issue can be reproduced at will with the following steps:
Create a simple Order Release using a simple TEST_order.xml file.
Then Create a Shipment using a simple TEST_Shipment.xml file.
Under the Equipment tab in the UI, notice that the Pickup Stop Number and and Drop Off Stop Number are both empty.
Run the TEST_Shipment.xml again, and check the Shipment under the Equipment tab in the UI, notice that the Pickup Stop Number and and Drop Off Stop Number are both populated now.
Sign In with your My Oracle Support account
Don't have a My Oracle Support account? Click to get started
Million Knowledge Articles and hundreds of Community platforms