Stop Site Sequence Numbers Getting Reset From Site Hub JET UI Hierarchy Workbench After Making Custom Change To How Sequence Is Displayed (Doc ID 2952390.1)

Last updated on JULY 07, 2023

Applies to:

Symptoms

Stop Site sequence numbers getting reset from Site Hub JET UI Hierarchy Workbench.

User wants the stop site sequence numbers to be in multiple of 10, so applied datafix to update the sequence number of the stops as 10, 20,30..and so on. But found that if any user moves the stop from one position to another position from Hierarchy workbench JET UI page then the sequence numbers are again reset to 1, 2,3,.. and so on. Need the stop sequence numbers should always appear in multiple of 10. 


The issue can be reproduced at will with the following steps:
1. Custom change via script to sequence number of the stops as 10, 20,30.
2. Site Management User > Site Home
3. Hierarchies > Hierarchy Workbench
4. Review the Site data in Hierarchy Workbench and were reset to 1,2,3... and not 10, 20, 30...

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.