Blade Cannot be Powered On After ILOM/ BIOS Upgrade, LSI Firmware Upgrade Would Fix This.
(Doc ID 1296521.1)
Last updated on MARCH 01, 2024
Applies to:
Sun Blade 6048 System - Version Not Applicable to Not Applicable [Release N/A]Sun Blade 6000 System - Version Not Applicable to Not Applicable [Release N/A]
Sun Blade X6440 Server Module - Version Not Applicable to Not Applicable [Release N/A]
Sun Blade X6220 Server Module - Version Not Applicable to Not Applicable [Release N/A]
Sun Netra 6000 System - Version Not Applicable to Not Applicable [Release N/A]
Information in this document applies to any platform.
Currency Checked 22/04/2016
Symptoms
AMD Based Server Blades fail to power up after the ILOM/BIOS has been upgraded.
* The Sun Fire X6220 was used in this case.
* This applies to AMD based servers with on board LSI controller.
Changes
In this situation, the ILOM/BIOS is upgraded, and the server will not power up with disks in the slots.
As the LSI firmware is deemed to be out of sync, we must observe in the firmware release notes, the supported version of ILOM, BIOS and LSI firmware.
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
| Symptoms |
| Changes |
| Cause |
| Solution |