My Oracle Support Banner

SL150 - How to Use the KLM Card and USB Stick from Old Base Chassis to Prevent a S/N Mismatch (Doc ID 2020327.1)

Last updated on JANUARY 16, 2019

Applies to:

StorageTek SL150 Modular Tape Library - Version All Versions to All Versions [Release All Releases]
Information in this document applies to any platform.

We need to take this special process when we have already replaced the robotics module and returned it and we have not been able to fully initialize the library in the meanwhile, so that any subsequent replacement of either the Op Panel or the Base Module would cause a serial number mismatch. In this situation the configuration in the KLC card, located at the robotics CRU, has not been updated with the current configuration and serial number. If we now just replace the base chassis, which holds the KLM card and USB stick, we would corrupt the current configuration and end up in serial number mismatch condition. The purpose of this process is to avoid the serial number mismatch condition, while replacing the base chassis.

Goal

This document will assist with the steps needed to use the existing USB stick and the KLM card from the original base chassis, after replacement.

Solution

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Goal
Solution
References

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.