New Routes Stuck In Configured State In NOAM GUI but Event 10051 Reports Different Route Failure

(Doc ID 2350800.1)

Last updated on FEBRUARY 07, 2018

Applies to:

Oracle Communications Diameter Signaling Router (DSR) - Version DSR 5.0 and later
Information in this document applies to any platform.

Symptoms

Attempts to add new routes on recently replaced servers was successful in the GUI but fails to transition to 'Deployed' status (remained 'Configured') and is not inserted into the route table on the server kernel. On the GUI, 10051 EventID MN alarm exists, but for a different route on this same server.

Changes

Servers were replaced with newer generation hardware. [This man not be the only possible trigger for this problem].

Cause

	Sign In with your My Oracle Support account
	Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms