How to apply Filter In Packet-trace to capture trace from one IP in VLAN. (Doc ID 2546756.1)

Last updated on NOVEMBER 21, 2023

Applies to:

Goal

On SCZ810m1p11 release SBC does not apply filter set in "packet-trace local start" command. For example, we need SBC to catch traffic on address 172.xx.xx.xx of the network-interface "access:301" only, so customer tried to do it with below listed commands:

1) packet-trace local start access:301 "172.xx.xx.xx"
2) packet-trace local start access:301 "ip-addr==172.xx.xx.xx"
3) packet-trace local start access:301 172.xx.xx.xx

In all three cases SBC captures traffic on all the addresses configured on actual network-interface "access:301".

Solution

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.