Fujitsu SPARC M12-1/M12-2/M12-2S, Fujitsu M10-1/M10-4/M10-4S Console hangs after initiating PPAR POST Diagnostics
(Doc ID 2646655.1)
Last updated on OCTOBER 13, 2023
Applies to:
Fujitsu SPARC M12-1 - Version All Versions to All Versions [Release All Releases]Fujitsu M10-4S - Version All Versions to All Versions [Release All Releases]
Fujitsu M10-4 - Version All Versions to All Versions [Release All Releases]
Fujitsu SPARC M12-2S - Version All Versions to All Versions [Release All Releases]
Fujitsu M10-1 - Version All Versions to All Versions [Release All Releases]
Information in this document applies to any platform.
Symptoms
After starting a PPAR, the XSCF console command hangs and does not respond to any further keyboard input.
Exit from the console session (#.) is not successful.
There are no errors in the platform logs.
Hardware looks good.
Reboot XSCF ('rebootxscf') does not change behavior.
The HOST and/or LDOMs, if set to autoboot, successfully start.
Changes
XCP firmware may have just been updated. The symptoms above have been encountered but not limited to the following XCP releases:
M12: XCP 3071
M10: XCP 2360
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
Symptoms |
Changes |
Cause |
Solution |