My Oracle Support Banner

Not Able To Edit "Reserved Ingress MPS" In Capacity Configuration Set After The Upgrade From 8.4.0.3 To 8.4.0.5 (Doc ID 2724125.1)

Last updated on NOVEMBER 04, 2020

Applies to:

Oracle Communications Diameter Signaling Router (DSR) - Version DSR 8.4.0 to DSR 8.4.0 [Release DSR 8.0]
Information in this document applies to any platform.

Symptoms

Not able to edit "Reserved Ingress MPS" in Capacity Configuration Set (not associated with any connection).

Full Path:

Main Menu: Diameter -> Configuration -> Configuration Sets -> Capacity Configuration Sets

 

If the set is created with a value defined below the "Max Ingress MPS",
a. Edit with a value less than initial "Reserved Ingress MPS"
you can edit it with values less than the original "Reserved Ingress MPS"
b. Edit with a value greater than initial "Reserved Ingress MPS"
It cannot be increased, there is no error reported on the GUI and if it is refreshed, the value is not modified.
c. After a new value is set (lower than initial "Reserved Ingress MPS" value, the new value becomes the maximum value and it cannot be increased, only reduced.

If the set is created with a default value defined as 0 for "Max Ingress MPS",
a. Edit with a value greater than initial "Reserved Ingress MPS"=0
It cannot be increased, there is no error reported on the GUI and if it is refreshed, the value is not modified.

Changes

Software upgrade from 8.4.0.3 to 8.4.0.5

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
 Main Menu: Diameter -> Configuration -> Configuration Sets -> Capacity Configuration Sets
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.